- Unit weight: 42 lbs
- Max HP: 130 HP
- Max Motor Weight: 375 lbs
- Mounting Footprint: 14"H x 17.5"W
- Engine Mounting Plate: 14"H x 15.25"W
- Lift Speed Lock to Lock: 7.2 seconds
- Power requirements: 12 V
- Operation: Ball Screw Actuator
- Construction: Aluminum
- Controls: Standard 2-Button Switch w/16ft of cable (Longer cables can be purchased for special applications)
The Powrtran PTT130 unlocks the hidden performance potential in boats and motors. Our power trim and tilt features advanced engineering with a combination of features. The PTT130 is like a transom bracket and power trim and tilt all combined into one superior unit. It not only enhances top end speed, but also reduces fuel consumption, improves whole shots, stabilizes boat ride and tracking, and eliminates most plowing, porpoising, and chinewalking. The PTT130 has full power all the way up, and will not kick down from propeller force at any degree of trim.
The PTT130 is ideal for most boats, including pontoons. Best of all, The PTT130 is very economical. It cost less than most factory units and is easier, faster and less expensive to repair than factory hydraulic units. Simply put, the PTT130 has no equal.
Should service be necessary the actuator is removed in minutes by removing two clevis pins and unplugging the electrical cord. Just place the clevis pin in the hole in the lower port side of the PTT frame and continue boating.
The PTT130 is designed for clamp-on or direct bolt-on motors.