These rugged pole storage clips are made of a durable, flexible urethane
Can be attached to any flat surface to store your Superstick Push Pole or Anchor Pin during transport
Slight concave base allows the tension of the prongs to be adjusted by simply loosening or tightening the clip to the mounting surface
Combine Large Pole Storage Clips and Small Pole Storage Clips to make great Fishing Rod Holders
Sold in pairs
The push pole should be stored while fully retracted. Clip the storage clips to the push pole/ anchor pin (one clip close to each end will provide the most secure storage) and position the push pole/ anchor pin in various places to find the most suitable location on the boat. When you find a good location, trace around the clips. Remove the clips from the push pole/ anchor pin, position them over the traced areas and mark where a pilot hole should be drilled to attach the storage clips. (The slight concave base allows the tension of the prongs to be adjusted by simply loosening or tightening the clip to the mounting surface.)
If you can access the backside of the pilot hole, we recommend using a stainless steel screw and lock nut. If not, apply some type of silicone in the pilot hole and on the threads of a stainless wood screw before screwing it in the surface. (That will help prevent the screw from backing out over time.) Stainless steel washers (used as spacers) can be added under the storage clips (with the screw passing through them), so you can tighten down on the screws, without applying too much tension to the prongs. Beware, it will make the push pole/ anchor pin come out of the storage clips easier. Whether you add the spacers or not, you should consider burning a small hole in the middle of some double-sided Velcro and mounting it under the storage clips. This will allow you to quickly provide additional security while trailering or running to your next fishing hole.